Installation - Leviton Luma-Net LumaCAN Manual Del Usuario

2. INSTALLATION

1.
NOTE: If the Gateway will be installed into the Gateway enclosure, follow the enclosure
installation instructions prior to continuing the Gateway installation instructions.
2.
A. Connect leads per wiring diagram as
shown in Figure 1.
3.
sure that there are no stray strands) and push
firmly into appropriate plug connector location.
4. Tighten the screws on the plug connector
5. Tie the drain/shield wires together and insulate
6.
NOTE: A termination jumper is required
at both ends of the Luma-Net
Luma-Net ® connection terminal.
TM
7. Plug LumaCAN
terminal. The power segmentation switch
LumaCAN TM
setting. Paralleling LumaCAN
8.
9. Confirm the SD card is properly installed.
10. Connect power.
A.
B. Connect power at the terminal post or to power via LumaCAN
the LumaCAN TM
11.
A.
B.
12.
and LumaCAN TM
13.
FIGURE 2
1 9 2.1 68 . 9 0 . 88
No C o n fi g
® Connector.
® run.
TM
TM
connection
TM
http://www.Leviton.com
Page 5
FIGURE 1
®
Lu m a -N e t
Wire Connec tions
TM
Figure 3
Figure 2.
FIGURE 3
1 9 2 . 1 6 8 . 9 0 . 8 8
L N : 1 0 0 C AN : 1 0 0
Phoenix/Luma-Net Connector
®
address (LN)