Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENTS
Sink
Assembly
Hopper
Reset Button
(Reach up and under
protective shield to press)
49-4000291 Rev 0
Installation Instructions
Stopper
Splash
Guard
Sink
Sink
Gasket
Ring
Screws (3)
Snap Ring
Cushion Mount
Lower Mounting
Ring
Gasket
Screws
Elbow
(on some models)
PREPARATION
2. Remove old disposer or sink flange assembly.
3. Inspect drain line. If it is heavily coated with
hardened grease and accumulations, rout out with a
plumber's snake.
4. Remove old sealing materials and gasketing from
sink opening, both top and bottom.
NOTE:
dry and free of any residue to prevent leaks.
DISASSEMBLE TO INSTALL
releases and lift the entire hardware assembly from
the disposer.
2. Loosen the three screws from the upper mounting
ring and slide it toward the support flange.
Loosen
screws (3)
3. Insert a flat blade screwdriver under the snap ring
and remove it.
4. Separate the upper mounting ring and support flange
from the sink flange.
Lower
Mounting
Ring
Support
Remove
snap ring
7
Publicidad
