FR-Tec GRAND CHELEM Guia Del Usuario página 34

GAME MODE
1. Please check if your game requires X-INPUT or DIRECT-INPUT game mode.
2. D-INPUT is the default mode of the steering wheel
3. When in D-INPUT, pedal is Y-axis - Accelerator is R2 and brake is L2
4. Once the base is connected to the PC, the LED will light RED.
5. To switch to X-INPUT mode, press and hold down the PS/MODE button for 2 seconds while the RED LED flashes.
When the LED turns orange, this means that the change has been successful
OPERATING ON NINTENDO
1. Switch the Switch console off and place it in the dock.
2. Connect the gas and clutch pedals to the centre pedal using the RJ cables provided.
3. Connect the cable from the centre pedal to the corresponding port on the steering wheel base.
4. Connect the gear shift cable to the base of the steering wheel at the appropriate port.
5. Connect the steering wheel base to the USB port on the console dock.
6. Turn the Switch console on using the power button on the console.
7. Press the HOME button on the steering wheel to start playing
8. When playing, press the PS/HOME button to open the Switch's main menu
9. Press HOME button + "-" for screenshots.
ADJUSTING EQUIPMENT:
DESKTOP USE
No spanners or special tools are required to fit the han-
dwheel base to the table, simply tighten the clamps by
clamping the rear hexagonal tubes.
ALLEN KEYS:
The tools can be used to connect the pedals and to make
the necessary ergonomic adjustments to the pedals. Be
careful not to overtighten the screws to avoid damage.
32