MAG MG1000 Instrucciones De Uso página 55

• The connected 230V equipments are not working:
YES
Damaged voltage regulator.
Check if the plugged
equipment is malfunctioning.
Is the thermal protection in
the OFF position?
NO
Does the voltmeter
indicate voltage?
NO
Possible causes to check in this order
Loose cable or connector
Brushes in poor condition
25
YES
Place it in the "ON" position
Visually check the
equipment and control
panel wiring.
Replace brushes
Part nº 55 in page 30.
Replace the voltage
regulator.
Part nº 4 in page 30.