Palazzetti ECOFIRE Manual De Instrucciones página 20

2.3 - EXTERNAL AIR INTAKE
2.4 – FLUE
All flue sections must be accessible for inspection and remova-
ble for internal cleaning purposes (Fig.12)
2.4.1 DIRECT OUTLET ON OUTSIDE WALL
For installation in conformity with regulations, you must:
particularly windy areas, and in areas along the coast in general, an H
pot must be installed in an upright position to prevent smoke being
blown back into the room
If the stove is to be installed in an apartment block, we suggest
you seek the opinion of the administrator before installation.
2.4.2 FLUE GASES EXPELLED THROUGH A TRADITIONAL CHIMNEY
20
2.5 - INSERT VERSION (WITH PULL-OUT BASE)
The lower edge of the stove must be raised at least 1 cm off the
marble slab.
11) Fit an air and heat recovery grille in the top part of the false hood.
N.B. The feed hopper and its turning support are delivered
assembled on the left. They can be moved to the right by
loosening bolts (G) (Fig. 19)
In the front-feed version, the turning support is assembled at
the front.
In
1) First release the stove as indicated in the point below and slide the
unit out from the front using the two handles (X) (Y) as illustrated
(Fig. 20).
Fit the handles into the two slots, insert them in a horizontal position,
rotate them vertically and pull the stove out from the front.
the key from a horizontal to a vertical position).
key from a vertical to a horizontal position).
switch (W) that connects or disconnects the power supply.
2.5.1 - FRONT FRAME ASSEMBLY
·
turn
turn the
at the same time, operate a micro-