Makita M9000 Manual De Instrucciones página 4

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Applicable grinding wheel
Applicable cut-off wheel
Spindle thread
Max. spindle length
No load speed (n ) / Rated speed (n)
0
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s). The lightest and heaviest combinations, according to
EPTA-Procedure 01/2014, are shown in the table.
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
Wear safety glasses.
Always operate with two hands.
Do not use the wheel guard for cut-off
operations.
DOUBLE INSULATION
Only for EU countries
Due to the presence of hazardous compo-
nents in the equipment, used electrical and
electronic equipment may have a negative
impact on the environment and human
health.
Do not dispose of electrical and electronic
appliances with household waste!
In accordance with the European Directive
on waste electrical and electronic equipment
and its adaptation to national law, used
electrical and electronic equipment should
be collected separately and delivered to
a separate collection point for municipal
waste, operating in accordance with the
environmental protection regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
Max. wheel diameter
Max. wheel thickness
Max. wheel diameter
Max. wheel thickness
M9000
180 mm
7.2 mm
180 mm
4.0 mm
M14 or M16 or 5/8" (country specific)
-1
8,500 min
5.5 - 7.7 kg
Intended use
The tool is intended for grinding and cutting of metal
and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution
systems of between 220 V and 250 V
Switching operations of electric apparatus cause volt-
age fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.24 Ohms it can be pre-
sumed that there will be no negative effects. The mains
socket used for this device must be protected with a
fuse or protective circuit breaker having slow tripping
characteristics.
4 ENGLISH
M9001
230 mm
6.5 mm
230 mm
3.2 mm
26 mm
-1
6,600 min
466 mm
5.6 - 7.7 kg
/II