Publicidad
Idiomas disponibles
Idiomas disponibles
TO TRANSPORT
• Raise attachment lift to highest position
with attachment lift control.
• When pushing or towing your tractor, be
sure gearshift lever is in neutral position.
• Do not push or tow tractor at more than
five (5) MPH.
NOTE: To protect hood from damage
when transporting your tractor on a truck
or a trailer, be sure hood is closed and
secured to tractor. Use an appropriate
means of tying hood to tractor (rope, cord,
etc.).
TOWING
CARTS
AND
OTHER
ATTACH-
MENTS
Tow only the attachments
that are recom-
mended by and comply with specifications
of the manufacturer
of your tractor. Use
common sense when towing. Too heavy
of a load, while on a slope, is dangerous.
Tires can lose traction with the ground and
cause you to lose control of your tractor.
BEFORE
STARTING
THE ENGINE
CHECK
ENGINE
OIL
LEVEL
The engine in your tractor
has been
shipped, from the factory, already filled
with summer weight oil.
1. Check engine oil with tractor on level
ground.
2. Remove oil fill cap/dipstick
and wipe
clean, reinsert the dipstick and screw
cap tight, wait for a few seconds, re-
move and read oil level.
If necessary,
add oil until "FULE' mark on dipstick is
reached.
Do not overfill.
For cold weather operation you should
change oil for easier starting (See the
oil viscosity chart in the Maintenance
section of this manual).
• To change engine oil, see the Mainte-
nance section in this manual.
ADD GASOLINE
Fill fuel tank to bottom
of filler
neck.
Do
not overfill.
Use fresh,
clean,
regular
unleaded
gasoline
with a minimum
of
87 octane.
(Use of
leaded
gasoline
will
increase
carbon
and lead oxide
deposits
and reduce
valve
life).
Do not mix oil
with gasoline.
Purchase
fuel in quanti-
ties that can be used within
30 days to
assure
fuel freshness.
_,CAUTION:
Wipe off any spilled oil or
fuel. Do not store, spill or use gasoline
near an open flame.
IMPORTANT:
When operating in temper-
atures below32°F(0°C),
use fresh, clean
winter grade gasoline to help insure good
cold weather starting.
CAUTION:
Alcohol blended fuels (called
gasohol or using ethanol or methanol)
can
attract moisture which leads to separation
and formation of acids during storage.
Acidic gas can damage the fuel system
of an engine while in storage.
To avoid
engine problems, the fuel system should
be emptied before storage of 30 days
or longer.
Drain the gas tank, start the
engine and let it run until the fuel lines
and carburetor are empty.
Use fresh fuel
next season.
See Storage Instructions
for
additional
information.
Never use engine
or carburetor cleaner products in the fuel
tank or permanent
damage may occur.
TO START ENGINE
When
starting
the engine
for the first time
or if the engine
has run out of fuel, it will
take extra
cranking
time to move fuel from
the tank to the engine.
1.
Sit on seat in operating
position,
depress
clutch/brake
pedal and set
parking
brake.
2.
Place
gear shift lever
in neutral
posi-
tion.
3.
Move
attachment
clutch
to disengaged
position.
4.
Move throttle
control
to choke
position.
NOTE:
Before
starting,
read the warm
and cold starting
procedures
below.
5.
Insert
key into ignition
and turn key
clockwise
to start position
and release
key as soon as engine
starts.
Do not
run starter
continuously
for more than
fifteen
seconds
per minute.
If the
engine
does
not start after several
attempts,
move throttle
control
to fast
position,
wait a few minutes
and try
again.
If engine
still does
not start,
move the throttle
control
back to the
choke
position
and retry.
WARM
WEATHER
STARTING
(50 ° F and
above)
6.
When
engine
starts,
move the throttle
control
to the fast position.
• The attachments
and ground
drive can
now be used.
If the engine
does
not
accept
the load,
restart
the engine
and
allow
it to warm
up for one minute
using
the choke
as described
above.
15
Publicidad
