Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
TO AVOID
SERIOUS
INJURY,
BEFORE
PERFORMING
ANY
SERVICE
OR ADJUSTMENTS:
1.
Depress
clutch/brake
pedal fully and set parking
brake.
2.
Place
gearshift
lever in neutral
position.
3.
Place
attachment
clutch
in "DISENGAGED"
position.
4.
Turn ignition
key to "STOP"
and remove
key.
5.
Make sure the blades
and all moving
parts have completely
stopped.
6.
Disconnect
spark
plug wire from spark
plug and place
wire where
it cannot
come
in contact
with plug.
TO REMOVE
MOWER
Mower will be easier to remove from the
right side of tractor.
1. Place attachment
clutch in "DISEN-
GAGED" position.
2. Move attachment
lift lever forward to
lower mower to its lowest position.
3. Roll belt off engine pulley.
4. Remove small retainer spring, and
remove clutch spring off pulley bolt.
5. Remove large retainer spring, slide
collar off and push housing guide out
of bracket.
6. Disconnect
anti-sway
bar from chassis
bracket by removing retainer spring.
7. Disconnect
suspension
arms from rear
deck brackets by removing retainer
springs.
8. Disconnect front links from deck by
removing retainer springs.
9. Raise lift leverto raise suspension
arms.
Slide
mower
out from
under tractor.
IMPORTANT:
If an attachment
other than
the mower deck is to be mounted on the
tractor, remove the front links and hook
the clutch spring Into square hole in frame.
TO INSTALL
MOWER
1.
Raise attachment
lift lever to its highest
position.
2.
Slide mower
under
tractor
with deflec-
tor shield
to right side of tractor.
3.
Lower
lift lever to its lowest
position.
4.
Connect
front links to mower
deck and
secure
with retainer
springs.
5.
Connect
suspension
arms to rear deck
brackets
and secure
with retainer
springs.
6.
Connect
anti-sway
bar
to
chassis
bracket
and secure
with retainer
spring.
7.
Push clutch
cable
housing
guide
into
bracket,
slide collar
onto guide and
secure
with large retainer
spring.
8.
Place flat washer
and clutch
spring
on
idler pulley
bolt and secure
with small
retainer
spring.
9.
Make sure
belt is inside
the belt keeper
at the idler and on both sides of the
wire belt keeper
as shown.
10. Install
belt onto engine
pulley.
IMPORTANT:
Check
belt for proper
rout-
ing in all mower
pulley
grooves.
Small
Retainer
Bpnng
Wire
Belt Keeper
Clutch
Clutch
Sprin_
Retainer
Spnng
Suspension
Aims
Engine
I" _Square
Hole
Anti Bwa'
Retainer Springs
(Both Sides)
Housin(
Large Retainer
Spring
21
Deflector
Shield
Publicidad
