Publicidad
Idiomas disponibles
Idiomas disponibles
EN
FR
DE
ES
PROBLEM
Motor buzzes but fails to
run.
No Water
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To
return your used device, please use the return and collection systems or contact the retailer where
the product was purchased. They can take this product for environmental safe recycling.
IT
PT
NL
SV DA NO
ENGLISH(Original Instructions)
POSSIBLE CAUSE
Supply voltage below minimum.
System has residual pressure.
Voltage loss due to extension cord.
Pressure washer not used for long
periods.
Residual friction among com- po-
nents. Unit might hum.
Quick connect assembly is attached
in reverse.
Water supply is OFF.
Kink in the garden hose.
FI
HU CS RU RO PL
SOLUTION
Verify that only the pressure washer is running
on this circuit.
Turn unit "OFF", squeeze trigger on spray
wand to release pressure, then turn unit "ON"
Unplug any extension cords attached and plug
the unit directly into the outlet.
Call the Toll-Free Hotline.
Disconnect water supply and power ON for 2
to 3 seconds, repeat couple times or until the
motor starts.
Verify that Inlet adapter (G2) is attached to
machine's water inlet and that he quick con-
nect coupler (G1) is attached to garden hose.
Turn ON water supply.
Remove kink in garden hose.
DISPOSAL
24
SL
HR ET
LT
LV SK BG
Publicidad
