Bimar SE1800.EU Folleto De Instrucciones página 10

Fax +32 030 9904733
The appliance must not be used in dusty environments or in the
presence of extremely volatile materials which could obstruct
grids or heat exchanger, nor in very damp environments, in the
presence of inflammable products, or out of doors in the open.
Any other use is to be considered inappropriate and therefore
dangerous. The manufacturer cannot be held responsible for
eventual damage caused by inappropriate, improper or
irresponsible use and/or for repairs made to the product by
unauthorised personnel.
• This stove is a radiant appliance the elements of which are
visibly incandescent and exceed a temperature of 650°C; the
appliance gets hot when working; so only touch the handle and
plastic switch. Avoid contact with the heating element. The
fireguard of this heater is intended to prevent direct access to
heating elements and must be in place when the heater is in use,
but the fireguard does not give full protection for young
children and for infirm person.
• Ensure that the appliance come into contact with water or other
liquids. If this should happen, never immerse hands in the
liquid but remove the plug from the socket first of all. Dry the
appliance carefully and check that all the electric parts are dry.
If in doubt, call a qualified expert.
•Children of less than 3 years should be kept away unless
continuously supervised. Children aged from 3 years and less
than 8 years shall only switch on/off the appliance provided that
it has been placed or installed in its intended normal operating
position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand
the hazards involved. Children aged from 3 years and less than
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
10/36
Assembly page 10/36