Bimar SE1800.EU Folleto De Instrucciones página 12

Fax +32 030 9904733
and switch it on after these controls: in case of doubt,
contact professionally qualified persons.
•WARNING: this heater is not equipped with a device to
control the room temperature. Do not use this heater in
small rooms when they are occupied by person not capable
of leaving the room on their own, unless constant
supervision is provided.
•Do not pull on the power cord or the appliance to unplug
the appliance from the electric socket.
• If the electric cord is damaged, it has to be replaced by the
supplier or an authorized service center or a professionally
qualified, to avoid any risks.
INSTALLATION
•
After removing the packing materials, check the integrity of the appliance; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
danger; but dispose of them in accordance with current law.
• Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity, and that the electric plug is grounded. In the event of incompatibility between the
electric outlet and the plug of the appliance, have the outlet replaced with another more suitable
type by professionally qualified personnel, who will make sure that the section of the wires of the
outlet is appropriate for the absorbed power of the appliance. In general, the use of adapters or
extension cords is not recommended; if their use is indispensable, they must conform to existing
safety standards and their current capacity (amperes) must not be less that the maximum of the
appliance.
• The appliance must not be positioned immediately under a socket.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Position the heater:
- on a stable, flat (because the appliance could tip over) and smooth support surface.
- far from other sources of heat, inflammable materials (curtains, carpets, etc.), inflammable gases
or explosive materials (spray cans) and from materials that can deform on exposure to heat.
- 1 meter away from walls and at least 100 cm from the ceiling: if the heater is located under a
patio, make sure that the patio roof will not be damaged or catch fire from the heat.
- far from ponds or swimming pools, etc., to avoid electrical shock or the appliance falling in: if
this should happen, first remove the plug from the socket, then raise the appliance and dry it
perfectly before turning it on again (if in doubt, have it checked by professionally qualified
personnel).
- far from places where it could be hit.
• To orient the infrared radiant element and heat in the most convenient way, adjust the inclination of
the heating part (angle = 25° max), see picture.
• Make sure that the cable is correctly positioned with ring, that it is not touching hot elements or
sharp edges, is not wound around the utensil, is not twisted up on itself or in the way to prevent the
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
12/36
Assembly page 12/36