Publicidad
Idiomas disponibles
Idiomas disponibles
EN
DESCRIPTION
-
Wireless microphone with superior sound, stable operation and excellent interference behaviour.
-
The microphone integrates the ID Pilot function which pairs the receiver and transmitter with a unique
16-bit code, preventing other microphones from interfering even on the same frequency. In addition, the
diversity reception with two antennas ensures the best RF reception.
-
The display on the microphone and on the receiver easily informs about frequency and battery status.
Facilitating the control of microphones.
-
The transmitter uses an integrated audio and transmission management solution on a single chip, with
frequency selection and efficient power management to maximise battery life. FM modulation technology
with high sound quality.
-
The receiver and microphone channels are quickly synchronised with the IR synchronisation function.
-
UHF frequency range with selectable transmission channels.
-
Receiver with colour display and low noise balanced and unbalanced output for easy connection.
SONAIR-PRO-2M: dual receiver + 2 hand-held microphone.
-
SONAIR-PRO-2MP: dual receiver + 1 hand-held+ 1 belt-pack with clip-on microphone.
CONTROLS AND FUNCTIONS
SONAIR-PRO-2M RECEIVER & SONAIR-PRO-2MP
1.- VOL | CH: multifunction controls.
-
rotation: independent volume controls for channels A and B on the audio outputs.
-
long press + rotate: enters the configuration mode and selects the channel (transmission
frequency), the channel number will be shaded when this mode is active
the configuration mode, long press again or wait a few seconds and it will automatically deactivate.
2.- SYNC: a long press activates the synchronisation of the transmission channel (frequency) and a short
press stops it. For more information, see section OPERATING INSTRUCTIONS - RECEIVER AND
TRANSMITTER SYNCHRONISATION.
3.- AF: audio signal indicator lights for channel A and channel B audio signals. It will light up orange when
1
receiving audio signal from the microphone. Do not allow the last red LED to illuminate as this will mean
that the signal is saturating; if this happens, decrease the volume of the channel.
4.- RF: radio frenquency signal indicator lights for channel A and channel B. It will light up green when
receiving radio frequency signal from the microphone.
5.- IR: IR sensor for synchronisation of the transmission channel (frequency).
6.- Information display.
7.-
: receiver on/off button and indicator light. Make a short press to switch on and a long press to switch
off the receiver.
1
1.- ANT A/B: antennas for signal reception of A and B channel microphones with diversity technology.
2.- MIX OUT: audio signal output of the mix of both channels A and B, 6.3 mm unbalanced jack connector.
3.- AUDIO OUT CH A/CH B: audio signal outputs for each independent channel A and B, balanced XLR
connectors.
4.- POWER IN: power input 12 V DC, 1 A.
A
B
680.10
MHz
402
CH
VOL 97%
1
2
3 4
5
6
2
3
A
B
680.10
MHz
402
CH
VOL 97%
1
2
3 4
5
6
2
3
e
f
a
A
b
680.10
MHz
c
402
CH
A B
679.70
MHz
398
CH
VOL 76%
VOL 97%
d
4
3
2
1
4
A B
679.70
MHz
A B
A
B
A
B
398
CH
VOL 76%
4
3
2
1
MUTE
4
- 2 -
B
A B
679.70
MHz
398
CH
VOL 76%
7
402
CH
CH
1
7
1
c
g
b
. To exit
402
CH
B
MHz
IR
Publicidad
