Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
ATTACHING THE SUPPORT BRACKETS
- Use appropriate hardware to fasten the supplied support
brackets to your wall .
- If fastening hardware supplied with this range hood is
appropriate for your wall type, enlarge the pilot holes using
a 1/4 in . (6 mm) drill bit . Install the plastic wall anchors
(CC) and fasten the brackets using the supplied tapping
screws (AA) .
INSTALLING THE DAMPER (IF NECESSARY)
WARNING:
Sharp edges . Wear safety gloves .
CAUTION:
Be very careful when installing the damper .
Applying too much force or bending the damper too much
may damage or break the damper hinge ends .
The damper is pre-installed at the factory. Make sure that it has
not come loose during shipping and that it opens freely. Re-
install it if necessary .
- Insert one end of the damper (3) into the hinge slot (4) at
the top of the range hood (A) .
- Gently bend the damper (3) and insert its other end into the
hinge slot (4) .
INSTALLING THE RANGE HOOD
CAUTION:
Make sure the range hood is secure before
releasing it .
- Hang the range hood on the range hood support bracket (D)
and mark the locations of the two mounting holes inside the
range hood . Take the range hood off the wall and drill two
pilot holes in the marked locations .
- If fastening hardware supplied with this range hood is
appropriate for your wall type, enlarge the pilot holes using a
1/4 in . (6 mm) drill bit and install the plastic wall anchors (CC) .
Lastly, hang the range hood back on the range hood support
bracket (D) and secure to the wall with two tapping screws
(AA) .
QR811
IMPORTANT:
For drywall or plaster walls, support bracket (D) should be secured to wood
wall studs or a support structure directly (without supplied anchors (CC)).
CC
D
4
A
Fig. 7
CC
CC
AA
10
Fig. 6
3
3
Fig. 8
AA
Publicidad
