Hotpoint 22 Manual Del Propietario Y Instalación página 15

Installation Instructions
DOOR ALIGNMENT
After leveling, make sure that doors are even at the top,
To make the doors even, adjust the refrigerator door,
Using a 5/16" socket wrench, turn the door adjusting
screw to the right to raise the door, to the lefl to lower
it, (A nylon plug, embedded in the threads of the pin,
prevents the pin from turning unless a wrench is used,)
After one or two turns of the wrench, ()pen and close
the refrigerator door and check the alignment at the
top of the doors.
To removethebase
grille, openthedoo_s
andthen pullthe
grille straightout
5/16" Socket
/" Wrench
--_1_ Raise
INSTALLING THE WATER LINE
(ON SOME MODELS)
BEFORE YOU BEGIN
When connecting a GE Reverse Osmosis Water System to
your refrigerator, the only approved installation is with a
GE RVKIT,
If the water supply to the refrigerator is from a Reverse
Osmosis Water Filfration System AND the refrigerator also
has a water filter, use the refi_igerator's filter bypass plug,
Using the refiigerator's water filtration cm'tridge in
conjunction with the RO fiher can result in hollow ice
cubes and slower water Ilow from the water dispenser.
This water line installation is not warranted by the
refrigerator or
icemaker manufacturer, Follow these
instructions carefully to minimize the risk of expensive
water damage,
Water hammer (water banging in the pipes) in house
plumbing can cause damage to refrigerator parts and
lead to water leakage or flooding Call a qualified
plumber to correct water hammer before installing
the water supply line to the refrigerator.
BEFORE YOU BEGIN (CONT.)
To prevent burns and product damage, do not hook
up the water line to the hot water line.
If you use your refrigerator before connecting the
water line, make sure the icemaker power switch is
in the OFF position.
Do not install the icemaker robing in areas where
temperatures fall below freezing,
When using any electrical device (such as a power drill)
during installation, be sure the device is insulated or
wired in a manner to prevent the hazard of electric
shock.
All installations must be in accordance with local
plumbing code requirements.
15