Publicidad
Idiomas disponibles
Idiomas disponibles
• You can view the measured values by short pressing (less than 0.5s) the trigger (NOTE: The
measured values will be cleared by long press). This operation is applicable to processes that
require regular monitoring of temperature. If no timing is needed, just do not set the time.
Operation
1. When the lock measurement function is turned on, short press the trigger to enable it. The
icon will appear on thermometer screen and the SCAN icon will flash. Thermometer will
continuously measure the target temperature.
2. Pull the trigger again, the
Thermometer stops the measurement and holds the last measured value.
NOTE: During measurement, it is best to ensure that the measured target diameter
is twice the spot size (S) of thermometer, and then determine the test distance (D)
according to the D:S diagram (refer to D:S part).
Short press the MODE button to switch the "MAX→MIN→AVG→DIF" measurement mode in
tum and the temperature value of the corresponding mode will be shown in the auxiliary display
area (as shown below).
Short press the
the laser indicator
position you are measuring during temperature measurement.
NOTE: Please follow the laser precautions when the laser is turned on to avoid
damage to human or animal eyes.
Short press the HI/LO button to turn the high/low limit alarm function on and off in sequence.
When HI limit alarm function is turned on and the measured temperature value is higher than
the set high alarm limit, the red LED and HI indicator flash. If the audible alarm function has
been turned on, the buzzer will beep.
When LO limit alarm function is turned on and the measured temperature value is lower than
the set low alarm limit, the blue LED and LO indicator flash. If the audible alarm function has
been turned on, the buzzer will beep.
16
and SCAN icons disappear, and the HOLD icon appears.
MAX/MIN/AVG/DIF VALUE READING
MODE
LASER INDICATION FUNCTION ON/OFF
button to turn on/off the laser indication function. When it is turned on,
will be displayed on the LCD, and the laser will accurately indicate the
HIGH/LOW TEMPERATURE ALARM ON/OFF
MODE
MODE
Publicidad
