Ega Master 51678 Manual De Instrucciones página 18

In the HOLD interface, short press the SET button until emissivity setting is displayed. Short
press the button to quickly select the preset emissivity value (P1-P5). If no desired value
among the preset values, select any value closest to the emissivity, and adjust it by pressing the
button or
per second by long press (see Figure 3).
In the HOLD interface, short press the SET button until temperature unit setting is displayed,
and switch between ºC and °F by pressing the
In the HOLD interface, short press the SET button until audible alarm setting is displayed,
and turn on/off the audible alarm by pressing the
In the HOLD interface, short press the SET button until lock measurement setting is
displayed, and turn on/off the lock measurement by pressing the
the lock measurement is turned on, press the
for the lock measurement. At this time, the selected time position flashes, and the time value
can be adjusted by pressing the
function.
As the distance (D) from the target being measured to thermometer increases, the spot size
(S) on the measured area becomes larger. The relationship between the distance and the spot
size is as shown below.
18
EMISSIVITY SETTING
button. Add or subtract 0.01 each time by short press, and add or subtract 0.1
TEMPERATURE UNIT SETTING
AUDIBLE ALARM SETTING
LOCK MEASUREMENT SETTING
button or
D:S ( DISTANCE COEFFICIENT )
Spot Size@ Distance D:S=20:1
button or button.
button or
button to perform the timing setting "00:00"
button. Set timing to "00:00" to turn off timing
D:S=20:1
button.
button or button. When