Designers Fountain ASTREA Instrucciones De Instalación página 9

INSTALLATION (CONTINUED)
5
MOUNT THE MOTOR
 Lift the hanger ball (E) up and
through the mounting bracket (A)
opening, and allow the hanger
ball (E) to sit in the bottom of the
mounting bracket (A).
NOTE: The mounting bracket (A) has
a guide near the bottom that
aligns with the groove in the
hanger ball (E).
 Make sure the hanger ball (E)
locks in place with the guide on the
mounting bracket (A).
6
CONNECT THE WIRES
 Ensure the bump in the rear of the
mounting bracket (A) is aligned with the
hanger ball (E) notch.
 Insert the receiver (S) into the mounting
bracket (A).
 Connect the ground supply wire to the
ground mounting bracket (A) wire, ground
receiver (S) wire and ground wire on the
hanger ball (E) using a wire nut (EE).
 Connect the white supply wire to the white
receiver (S) wire using a wire nut (EE).
Connect the black supply wire to the black
receiver (S) wire using a wire nut (EE).
 Connect the male and female quick
connectors together.
 Secure each join with electrical tape. Tuck
the wire connections into the outlet box.
A
S
9
E
I
J
M
A
EE
S
A
I