Onlyfire 7017 Manual Del Propietário página 7

Portable Propane Gas Fire Pit
F-FPR7017-BS1
CONNECTION:
1. Be sure the cylinder valve and appliance valves are "off".
2. Place full LP gas cylinder on tank stabilizer ring.
3. Center the nipple in the cylinder valve and hold in place.
4. Using the other hand, turn the hand wheel clockwise until there is a positive stop. Do not use
tools.
5. Hand tighten only. When making the connection, hold the regulator in a straight line with the
cylinder valve, so as not to cross thread the connection.
6. Leak test the connection. See section named "LEAK TEST".
LEAK TEST:
1. DO NOT USE OR PERMIT SOURCES OF IGNITION IN THE AREA WHILE DOING THE LEAK TEST.
THIS INCLUDES SMOKING.
2. Leak testing should be done once per year or whenever the LP gas cylinder or any other gas
system part is taken apart, serviced or replaced, whichever is more frequent.
3. Ensure all gas system coupling joints are tight and properly attached.
4. Prepare a leak testing solution of half liquid detergent and half water.
5. Apply the solution to the LP gas delivery system
6. The leak(s) must be stopped by tightening the loose joints, if possible, or by replacing the
faulty parts(s) with the part(s) recommended by the appliance manufacturer.
THE APPLIANCE IS NOT TO BE USED UNTIL ANY LEAK IS CORRECTED.
• A gas appliance repairman or LP gas dealer should be called if attempts to stop the leak(s) are
unsuccessful and, in such case, the LP gas supply must be shut off at the cylinder valve or the
cylinder must be removed from the appliance until the leak(s) is corrected.
• Inspect hose prior to each use of the unit. The hose assembly must be replaced prior to the
appliance being put into operation if there is evidence of excessive abrasion or wear, or if the
hose is damaged. Contact Onlyfire Brands Inc. should you require a replacement hose.
• Inspect burner prior to each use. Burner must be replaced prior to the appliance being put into
operation if there is evidence of damage. Replacement burners are available from Onlyfire
Brands Inc.
• Should any part of this appliance (including the burner) become soiled or dirty, wipe lightly
with a damp cloth. Do not use flammable or corrosive cleaning products on or near this unit.
• Ensure that gas hose is placed in an area where it is unlikely to be tripped over (such as
pathways or trails) or subject to other accidental damage.
6