V-TAC SUN-5K-SG04LP3-EU Manual De Instrucciones página 34

Generator
Power: 6000W
V_L1: 230V
V_L2: 230V
V_L3: 230V
Battery Setting
Lithium Mode
00
Shutdown
10%
Low Batt 20%
Restart 40%
Battery Setting
①
Float V Shutdown
53.6V
Low Batt
Absorption V 57.6V
Restart
Equalization V
57.6V TEMPCO(mV/C/Cell)
Equalization Days
30 days
Equalization Hours
3.0 hours
Recommended ba�ery se�ngs
Battery Type
AGM (or PCC)
Gel
Wet
Lithium
Today=10 KWH
Total =10 KWH
P_L1: 2KW
P_L2: 2KW
P_L3: 2KW
Batt
Set3
③
20%
35%
Batt
Set3
50%
②
-5
Batt Resistance
25mOhms
Absorption Stage
14.2V (57.6V)
14.1V (56.4V)
14.7V (59.0V)
Follow its BMS voltage parameters
This page tells generator output voltage, frequency,
power. And, how much energy is used from generator.
Lithium Mode: This is BMS protocol.Please reference
the document(Approved Ba�ery).
Shutdown 10%: It indicates the inverter will shutdown
if the SOC below this value.
Low Ba� 20%: It indicates the inverter will alarm if the
SOC below this value.
Restart 40%: Ba�ery voltage at 40% AC output will
resume.
There are 3 stages of charging the Ba�ery .
This is for professional installers, you can keep it
if you do not know.
Shutdown 20%: The inverter will shutdown if the SOC
below this value.
Low Ba� 35%: The inverter will alarm if the SOC
below this value.
Restart 50%: Ba�ery SOC at 50% AC output will resume.
Float Stage
13.4V (53.6V)
13.5V (54.0V)
13.7V (55.0V)
- 32 -
①
②
③
Torque value
(every 30 days 3hr )
14.2V(57.6V)
14.7V(59.0V)