Publicidad
Idiomas disponibles
Idiomas disponibles
Your pressure washer requires some assembly and is
ready for use only after it has been properly serviced
with the recommended
oil and fuel.
If you have any problems
with the assembly
of
your pressure
washer,
please call the pressure
washer helpline at 1-800-222-3136.
IMPORTANT:
Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
REMOVE
PRESSURE
WASHER
FROM CARTON
•
Open carton and slice two corners opposite guide
handle from top to bottom so the panel can be
folded down flat.
•
Remove hose reel box, fillers, and parts bag
shipped with your pressure washer.
•
Remove spray gun, nozzle extension and engine
oil from fillers.
•
Roll the pressure washer out the open end of the carton.
•
Check carton for additional loose parts.
CARTON
CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
•
The main unit
•
Hose reel and mounting components
•
High pressure hose
•
Spray gun
•
Nozzle extension with Hi/Lo adjustable nozzle
•
Handle
•
Engine oil
•
Parts bag, which includes:
•
Owner's manual
•
Maintenance kit
•
Handle attachment hardware
•
Registration card
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration shown on page 7. If any parts are missing
or damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING
YOUR PRESSURE
WASHER
Your Craftsman pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
•
Attach handle and hooks.
•
Attach hose reel.
•
Add oil to engine crankcase.
•
Add fuel to fuel tank.
•
Connect high pressure hose to the spray gun and
the pump.
•
Connect water supply to the pump.
Attach
Handle
and Hooks
•
Place the handle onto the handle supports already
connected to the main unit. Make sure the holes in
the handle align with the holes on the handle
supports.
Align
Holes
Handle
Handle
Supports
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
•
Insert the carriage bolt through the hole on the right
side of the handle (viewing from rear of unit) and
attach the plastic knob. Tighten the knob by hand.
•
Insert one of the "L" bolts (detergent bottle hook)
through the hole on the left side of the handle
(viewing from rear of unit) and attach the plastic
knob. Tighten the knob by hand. If not installed, add
the vinyl cap to the "L" bolt.
So,,""
._ Detergent
Bottle Hook
.J
Gun Hook
•
Insert the other "L" bolt (gun hook) through the hole
just under the billboard on the right side of the
handle (viewing from rear of unit). Hold the hook in
place with a pliers and attach the Iocknut with a
7/16" wrench. If not installed, add the vinyl cap to
the "L" bolt.
NOTE: Be sure to hold the hook in place with the
pliers until tight.
Publicidad
