Publicidad
Idiomas disponibles
Idiomas disponibles
Things You Need to Know About Your XLR8+ NPWT Device
The XLR8+ pump will be worn 24 hours a day
n
throughout your treatment and should be kept in the
black carrying bag provided.
Do not allow the XLR8+ device to get wet.
n
the tubing from the canister if you take a bath or shower.
Do not submerge the pump in water; keep it dry.
Keep the XLR8+ device plugged into a power outlet
n
whenever possible to keep the battery fully charged.
Always take the battery charger with you when you
leave home.
If the device gets wet,
n
If any food or liquid is spilled on the device,
n
immediately wipe it clean.
Do not use the battery charger
n
plug are damaged.
Keep the battery charger cord away
n
heated surfaces.
Always keep the XLR8+ turned ON
n
bleeding from the wound, or instructed by your health
care provider.
Do not change the settings on the XLR8+ device
n
unless instructed by your health care provider.
Quick Reminders
Turning the XLR8+ ON
Press and HOLD the
ON
the XLR8+ pump.
Turning the XLR8+ OFF
Press and HOLD the
OFF
the XLR8+ pump.
Troubleshooting Alerts
If the XLR8+ pump begins to display an alert,
please refer to the
Troubleshooting
For questions or information, contact InfuSystem NPWT Clinical Support at 1-844-534-1997.
Disconnect
unplug it immediately.
if the cord and/or
from
unless there is
Power Button
to power
Power Button
to power
section.
Power ON/OFF Button
Notify your health care provider
n
increase in fluid from the wound.
Never use expired supplies.
n
Stop the pump and contact your health care provider
n
immediately
if blood is noted in the canister or under
the dressing.
Canisters are single-use only
n
a minimum weekly, or when the canister is full.
Contact your health care provider immediately
n
signs of infection occur.
It's normal to hear the pump turning on and off
n
repressurizes your wound to keep it at the
appropriate settings.
If the XLR8+ device is off for two or more hours,
n
remove the dressing and foam, and place a moist
dressing on the wound. Once this is done, notify your
health care provider immediately.
Only use the battery charger provided
n
XLR8+ pump.
Electrical Shock Hazard.
n
device apart.
Changing the Canister
Only use Genadyne NPWT Canisters with the
XLR8+ NPWT System.
The XLR8+ canister should be changed when full or
at least once per week to control odor:
See back of XLR8+ NPWT pump for canister install.
Follow standard universal precautions, as the system
1
may contain body fluids.
Close the clamps on both the canister and
2
dressing tubing.
Disconnect the canister tubing from the dressing
3
tubing by twisting and separating the purple luer lock.
Remove the canister from the device.
4
Dispose of the canister according to the specified
5
institution protocol.
Insert a new canister.
6
Connect the new canister tubing to the dressing
7
tubing and initiate therapy as ordered.
of an unexpected
and must be changed at
if
as it
with your
Do not take the XLR8+ NPWT
Publicidad
