Publicidad
Idiomas disponibles
Idiomas disponibles
CUTCOUNTERTOP
OPENMNG
INSTALL DUCTWORK
1. Lay out and cut the cooktop
cut-out
far enough
FORWARD
so
downdraft
will fit behind
it.
2.
Set cooktop
in place
and slide
it as far forward
as possible.
Center
and square
it with edges
of countertop.
3.
Place
the plastic
template
against
the
back flange
of the
cooktop
and center
it. Trace
around
template
to mark
the
downdraft
opening.
4.
Remove
cooktop
from countertop.
5.
Cut downdraft
opening.
Be
careful
not to chip
edges
of
countertop.
MOUNT THE UNiT
MOUNTtNG
SCREWS
LEVELING
BRACKET
-
FLANGE FACING
OUT
/
LEVELING
BRACKET
FLANGE FACING
IN
1. Set downdraft
into opening.
Extend
leveling
brackets
to floor
of cabinet
so downdraft
sits straight.
(Note:
Leveling
brackets
can be removed
and re-attached
in other positions.
Bottom
flange
may have to face inward
in tight cabinet
installations.)
2.
Secure
the downdraft
to the countertop
as follows:
Hold the
downdraft
against
the back of countertop
cut-out
and tighten-
ing the 2 mounting
screws
(one
on each
end of unit)
on
underside
of countertop.
Use a wood shim between
screw and
underside
of granite
countertops.
3.
Screw
leveling
brackets
to bottom
of cabinet.
Tighten
screws
holding
leveling
bracket
to unit on each side.
CAUTION
- BEFORE
CUTTING
HOLE tN CABINET
FOR DUCT-
WORK:
Check for interference
with floor joists, wall studs, electri-
cal wiring
or plumbing.
ELBOW
....
10" ROUND
DUCT
ELBOW
1. Cut
hole
in cabinet
as well
as
holes
in wall
or floor
as
necessary.
2.
Mount the exterior
blower
and work back towards
the cabinet,
attaching
all ductwork,
elbows
and transitions
as previously
planned.
Tape all ductwork
connections
to make them secure
and air tight.
3. Connect
ductwork
to downdraft.
If necessary,
LOOSEN
nuts
and screws that hold remote blower
adapter
plate in place, and
slide outlet assembly
left or right to meet ductwork.
Re-tighten
screws
and nuts.
RNSTALLELECTRRCAL WRRRNG
1.
Mount a standard
wiring box, with 3-pronged
grounded
recep-
tacle,
inside
the kitchen
cabinet.
Make
sure the unit's power
cord can easily
reach
it.
2.
Run appropriate
power
cable
into cabinet
and connect
it to
electrical
box and receptacle.
3.
Exterior
blower
may not exceed
6.0 Amp rating.
4.
Run 2-wire
plus ground
power
cable from the remote
blower
to wiring
box on remote
blower
adapter
plate.
5. Connect
downdraft
wiring
to power cable from remote
blower.
Wire black to black, white
to white and green to green or bare
wire.
6.
Replace
wiring
box cover.
7.
Plug the downdraft's
power
cord into outlet.
Publicidad
