Makita UM110D Manual De Instrucciones página 12

Method of operation
1. Only use the equipment in good light and
visibility. During the winter season beware
of slippery or wet areas, ice and snow (risk
of slipping). Always ensure a safe footing on
slopes and be sure to walk and never run.
2. Take care against injury to feet and hands from
the cutting tool.
3. Never stand on a ladder and run the
equipment.
Never climb up into trees to perform cutting
4.
operation with the equipment.
Never work on unstable surfaces.
5.
6. Remove sand, stones, nails etc. found within
the working range. Foreign particles may dam-
age the cutting tool and can cause dangerous
kick-backs.
7. Should the cutting tool hit stones or other hard
objects, immediately switch off the motor and
inspect the cutting tool.
8. Inspect the cutting tool at short regular inter-
vals for damage (detection of hairline cracks
by means of tapping-noise test).
9. Before commencing cutting, the cutting tool
must have reached full working speed.
10. The cutting tool has to be equipped with the
appropriate guard. Never run the equipment
with damaged guards or without guards in
place!
11. All protective installations and guards sup-
plied with the equipment must be used during
operation.
12. Always remove the battery cartridge from the
equipment:
— whenever leaving the equipment
unattended;
before clearing a blockage;
—
— before checking, cleaning or working on
the equipment;
— after striking a foreign object;
whenever the equipment starts vibrating
—
abnormally.
13. Always ensure that the ventilation openings
are kept clear of debris.
14. Cutting means continues to run after the motor
is switched off.
15. If the blades stop moving due to the stuck of
foreign objects between the blades during
operation, switch off the tool and remove the
battery cartridge, and then remove the foreign
objects using tools such as pliers. Removing
the foreign objects by hand may cause an injury
for the reason that the blades may move in reac-
tion to removing the foreign objects.
16. Never stand on a ladder and run the equip-
ment. Never climb up into trees to perform
cutting operation with the equipment. Never
work on unstable surfaces.
Cutting Tools
Employ only the correct cutting tool for the job
in hand.
Maintenance instructions
The condition of the equipment, in particular of
1.
the cutting tool of the protective devices must
be checked before commencing work.
Turn off the motor and remove the battery
2.
cartridge before carrying out maintenance,
replacing cutting tools or cleaning the equip-
ment or cutting tool.
When not in use, store the equipment indoors
3.
in dry and high or locked-up place - out of the
reach of children. Clean and maintain before
storage.
SAVE THESE INSTRUCTIONS.
WARNING:
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
Cordless hedge trimmer safety
warnings
Do not use the hedge trimmer in bad weather
1.
conditions, especially when there is a risk of
lightning. This decreases the risk of being struck
by lightning.
2. Keep all power cords and cables away from
cutting area. Power cords or cables may be hid-
den in hedges or bushes and can be accidentally
cut by the blade.
3. Wear ear protection. Adequate protective equip-
ment will reduce the risk of hearing loss.
4. Hold the hedge trimmer by insulated gripping
surfaces only, because the blade may contact
hidden wiring. Blades contacting a "live" wire
may make exposed metal parts of the hedge trim-
mer "live" and could give the operator an electric
shock.
5. Keep all parts of the body away from the blade.
Do not remove cut material or hold material
to be cut when blades are moving. Blades
continue to move after the switch is turned off. A
moment of inattention while operating the hedge
trimmer may result in serious personal injury.
When clearing jammed material or servic-
6.
ing the hedge trimmer, make sure all power
switches are off and the battery pack is
removed or disconnected. Unexpected actua-
tion of the hedge trimmer while clearing jammed
material or servicing may result in serious per-
sonal injury.
7. Carry the hedge trimmer by the handle with the
blade stopped and taking care not to operate
any power switch. Proper carrying of the hedge
trimmer will decrease the risk of inadvertent start-
ing and resultant personal injury from the blades.
When transporting or storing the hedge trim-
8.
mer, always use the blade cover. Proper han-
dling of the hedge trimmer will decrease the risk of
personal injury from the blades.
12 ENGLISH
DO NOT let comfort or familiarity