Descargar Imprimir esta página

Ryobi RDC18BL Manual Del Usuario página 3

Publicidad

EN
ORIGINAL INSTRUCTIONS
Safety, performance, and dependability have been given top
priority in the design of your swift clean spot cleaner.
INTENDED USE
The swift clean spot cleaner is intended for the following
purposes:
Light-duty vacuuming of wet surfaces
Light-duty cleaning of upholstery
Use only the included cleaning solution. Do not use other
chemicals as this may damage the internal parts of the
product and void your warranty.
Do not use the product for any other purpose.
SWIFT CLEAN SPOT CLEANER SAFETY WARNINGS
This product can be used by persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given
supervision or instruction concerning use of the product
in a safe way and understand the hazards involved.
Children shall not play with the product.
The product is intended for household use only.
Do not direct liquid or steam towards equipment
containing electrical components.
Do not use the product if it has been dropped, if there are
visible signs of damage, or if it is leaking.
Keep the product out of reach of children when it is
energised or cooling down.
Never vacuum materials such as hot coals, cigarette
butts, matches, etc.
Do not use the product without dust bowl or filter in place.
Use extra care when using the product on stairs.
Do not use the product to pick up hard objects such as
nails, screws, coins, etc. Damage or injury could result.
Always close the battery cover and lock it in place
before use. Do not expose the battery pack to rain or
wet conditions.
Remove the battery when the product is not in use or
when changing accessories.
Rechargeable batteries are to be removed from the
product before being charged.
Exhausted batteries are to be removed from the product
and safely disposed of.
If the product is to be stored unused for a long period,
the batteries should be removed.
The supply terminals are not to be short-circuited.
ADDITIONAL SAFETY WARNINGS
Do not clean over electrical outlets located on the floor.
Water may drip from the product after use and can
puddle. To avoid damage, do not place the product on
wood or laminate surfaces. If setting the product aside
for more than a few minutes, place it on a towel or other
absorbent material to catch any drips. Failure to follow
these rules may cause serious injury or damage to
property.
Always hold the product at an angle with the nozzle
facing down when vacuuming liquids or when the waste
tank contains liquid waste. Positioning the product
on its side or holding it with its nozzle facing up could
allow liquid to enter the motor or battery. Battery packs
exposed to liquids can result in smoke or fire, serious
personal injury or property damage.
Apply the cleaning solution sparingly to complete the
task. Excessive foaming may occur if too much cleaning
solution is present.
During use, make sure the product does not get
submerged or doused in liquid, which could cause
shock, unit failure, or personal injury.
Never allow the amount of waste liquid to exceed the
max fill line. Failure to follow this rule may allow liquid
to enter the product, which could cause shock, property
damage, or personal injury.
If the waste tank contains liquid, do not turn the product
upside down as it may enter the motor.
ADDITIONAL BATTERY SAFETY WARNINGS
To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your
tool, battery pack, or charger in fluid or allow fluid to
flow inside them. Corrosive or conductive fluids, such
as seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a short
circuit.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and
labelling when transporting batteries by a third party.
Ensure that no batteries can come in contact with other
batteries or conductive materials while in transport by
protecting exposed connectors with insulating, non-
conductive caps or tape. Do not transport batteries
that are cracked or leaking. Check with the forwarding
company for further advice.
KNOW YOUR PRODUCT
See page 43.
1. Dirty tank
2. Carrying handle
3. Clean tank cap
4. Clean tank
5. Battery port
6. On/Off switch
7. Tank release lever
8. 2 in 1 wash tool
9. Crevice tool
10. Hose
11. Spray trigger
12. Cleaning solution
13. Rubber head
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
3

Publicidad

loading