Publicidad
Idiomas disponibles
Idiomas disponibles
Tube Nozzle (Cut open at angle)
NOTE:
Before using a partially filled tube, remove any hardened material with a long nail or piece of wire.
3. Pull the rod handle back to allow the tube to fit inside the carriage.
1.
WARNING
can be pinched between carriage and the piston.
2.
4. Insert tube into the carriage.
5. Push the rod handle forward until the piston is against the tube.
6. Push the Control Lever to the left position.
7. To remove the tube, push the Control Lever to the right position and pull the rod
handle back. Lift the tube out of the carriage.
INSTALLING SAUSAGE TYPE PACK
Always check sausage packs for punctures or damage before installing. Do not use a
damaged or frozen pack.
1. Push the Control Lever to the right position. Remove the battery pack.
2. Pull the rod handle back to allow the pack to fit inside the barrel.
3. Insert pack into barrel.
4. Cut off end of sausage pack per manufacturer's recommendation.
NOTE:
Before using a partially filled pack, remove any hardened material.
5. Insert nozzle supplied with the sausage pack into the nozzle cap and screw onto the
barrel.
6. Cut nozzle at an angle and size per manufacturer's recommendation to suit the job
(unless the nozzle is pre-cut). A smaller nozzle diameter requires more force to push
the caulk and reduces battery life.
7. Push the rod handle forward until the piston is against the pack.
8. Push the Control Lever to the left position
WARNING
accessories specifically recommended for this tool. Others may be hazardous.
1English1
Use Pin to break open inner seal
To reduce the risk of injury, keep hands out of the piston area of the tool. Fingers
Always remove battery pack before changing or removing accessories. Only use
English
-9
Publicidad
