EHEIM classicVARIO+e 250 Instrucciones De Uso página 16

English
Keep hose lengths as short as possible to prevent loops and kinks and minimise flow resistance.
7. Start up
⌦
G 1. Disconnect the connection between the outlet bend and the nozzle pipe on the pressure side.
2. Suction at the end of the outlet bend until the filter system automatically fills with water.
3. Once the water circuit has been established, reconnect the outlet bend to the nozzle pipe.
4. Plug the cable of the power supply unit into the pump head.
8. Operation
System requirements
Wifi-enabled end devices (smart phone, tablet, notebook etc.).
Creating a network
1. Insert the power cable of the power supply unit in the mains socket. The status LED t lights up.
• Status LED flashes white: Network is being searched for or created.
• The status LED illuminates blue: A new network has been created (master mode).
Connecting to the Wifi network
2. Open the network settings of your terminal device (smartphone, tablet, notebook etc.).
3. Connect the terminal device to the Wifi network (SSID) EHEIM classicVARIO XXXXXXXX.
4. Enter the network security key.
The network security key is found on the device.
Alternatively, you can also scan the QR code 1 (see label) to establish the connection.
Calling up the website
5. Open your web browser and enter the following address: http://192.168.1.1
Alternatively, you can also scan the QR code 2 (see label) to open the software in the browser.
Initial configuration
6. Select the desired language from the language selection and follow the instructions for the initial configuration.
Meaning of the status LED filter
• The status LED flashes white: The network is being searched for or created
• The status LED illuminates blue: The device is in master mode
• The status LED illuminates green: The device is connected to another EHEIM digital device
Reset
Touch the touch field below the status LED t for approx. 8 - 10 seconds until the status LED lights up in a colour change.
• If the status LED lights up green, the reset is complete and the device is created.
• Network security key (Key) and QR code 1 are invalid. Connection to the network is possible without the network security
key.
9. Cleaning
1. Unplug the mains plug of the power supply unit from the socket.
⌦
2. Close all shut-off levers of the double taps.
H
3. Separate both double taps by turning the screw sleeves to the left.
⌦
III. 4. Open all 4 clamping brackets and remove the pump head from the filter container.
5. Take out the filter insert by the handle and open the lid by turning it to the left.
6. Remove all filter mats and rinse them gently under running water.
7. Place the filter media back into the filter insert as shown in Figure 4.1 or 4.2 and close the lid.
8. Put the pump head back on the filter container.
16