Publicidad
1.1. You will need an extra hand and a mallet to
help with the assembly
1.2. A piece of wood or of another similar
V1
material should be used to prevent V1 from
being damaged.
B
V1
V1
A
V1
B
V1
1.4. To avoid scratching
while assembling, please lay parts A
on a piece of cardboard.
Step 1
Insert end cap V1 x 4 into arm A/B.
IMPORTANT: When completing each
and all following steps, please tighten
fully all hardware.
1.3. Make sure
to fully
insert V1 into A/B
,
eliminating any
remaining
gap.
the surface of parts
and B
8
Publicidad
