Saladax MyCare INSITE Manual Del Usuario página 5

Indicator Lights
MyCare Insite Analyser Front
LEDs on the MyCare Insite Analyser
This green LED indicates the Analyser status
Flashing: the Analyser is warming up and testing cannot be
started yet. (Note: warm-up takes approximately 10 min.)
On (green): the Analyser is warmed up and ready for use
Off: the Analyser is not plugged in
This blue LED indicates the Touch Screen connection status
On (blue): connection with the Touch Screen is established
Off: the Touch Screen is not connected
This blue LED indicates Bluetooth connection status
On (blue): connection with the Touch Screen is established
Flashing: Analyser Bluetooth is activated but no Touch
Screen is connected via Bluetooth
Off: Bluetooth is switched off
Note: Use of the USB cable connection is recommended to keep
the Touch Screen powered.
Operating and Storage Conditions
Operating conditions:
• 20 - 28°C; relative humidity: 10 – 85%
• A dry, clean, level surface with at least 10 cm of clearance on each side
Storage/Transport:
• 0 - 50°C; relative humidity: 5 – 85%
• Always use the transport lock when transporting the analyser or damage may result
PI MCI-EUR-ML-PKG Rev 01 English 5 / 12