This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
•
Changes or modifications not expressly approved by the party responsible for compliance could void
user's authority to operate the equipment.
C
BUTTONS AND FUNCTIONS
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the How to Use Basic Functions section of this manual.
1
2
3
4
5
6
1.
TEMP : Decreases temperate in 1°C (1°F) increments. Min. temperature is 16°C (60°F).
2.
ON/OFF: Turns the unit on or off.
3.
MODE: Scrolls through operation modes as follows: AUTO -> COOL -> DRY -> HEAT -> FAN
NOTE: Cooling only models do not have AUTO and HEAT mode.
4.
SWING: Starts and stops the horizontal louver movement. Hold down for 2 seconds to initiate vertical
louver auto swing feature(some units) .
5.
SLEEP: Saves energy during sleeping hours .
4
42
7
8
9 10
11
12
13
14
15