Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING AND STORAGE
CLEANING
Use a small brush to clean off the outside of the unit. Do not use strong detergents. Household
cleaners that contain aromatic oils such as pine and lemon, and solvents such as kerosene, can
damage plastic housing or handle. Wipe off any moisture with a soft cloth.
STORAGE
Never store the unit with fuel in the tank where fumes may reach an open fl ame or spark.
•
Allow the engine to cool before storing.
•
Lock up the unit to prevent unauthorized use or damage.
•
•
Store the unit in a dry, well-ventilated area.
•
Store the unit out of the reach of children.
Long Term Storage
1. Remove all fuel from the fuel tank and dispose in accordance with federal, state and local
regulations
2. Start the engine and allow it to run until it stalls. This ensures that all fuel has been drained from
the carburetor.
3. Allow the engine to cool.
4. Remove the spark plug and put 5 drops of any high quality motor oil or 2-cycle oil into the cylinder.
Pull the starter rope slowly to distribute the oil. Reinstall the spark plug.
NOTE:
Remove the spark plug and drain all of the oil from the cylinder before attempting to start
the blower after storage.
5. Thoroughly clean the unit and inspect it for any loose or damaged parts. Repair or replace
damaged parts and tighten loose screws, nuts or bolts. The unit is ready for storage.
TROUBLESHOOTING
PROBLEM
ENGINE WILL NOT START, IDLE OR ACCELERATE
Empty fuel tank
Primer bulb wasn't pressed enough
The fuel is old (over 30 days) and/or improperly
mixed
Fouled spark plug
Air fi lter is plugged
Improper idle speed
ENGINE LACKS POWER OR STALLS
The fuel is old (over 30 days) and/or
improperly mixed
Fouled spark plug
4
SOLUTION
Fill fuel tank with fuel
Slowly press primer bulb 10 times
Drain the fuel tank and add fresh, properly
mixed fuel
Replace or clean the spark plug
Replace or clean the air fi lter
Adjust according to the Idle Speed
Adjustments section.
Drain the fuel tank and add fresh, properly
mixed fuel
Replace or clean the spark plug
SPECIFICATIONS*
Engine Type ............................................................................................................. Air-Cooled, 2-Cycle
Displacement ................................................................................................................................. 27 cc
Idle Speed RPM ........................................................................................................... 3,200–4,400 rpm
Operating RPM ............................................................................................................ 6,900-7,200 rpm
Spark Plug Gap .................................................................................................... 0.025 inch (0.635 mm)
Lubrication ..................................................................................................................... Fuel/Oil Mixture
Fuel/Oil Ratio ................................................................................................................................... 50:1
Fuel Tank Capacity ............................................................................................................20 oz. (591 ml)
Approximate Unit Weight (No fuel) ............................................................................. 17.8 lbs. (8.07 kg)
*
All specifi cations are based on the latest product information available at the time of printing. We
reserve the right to make changes at any time without notice.
OPTIONAL ACCESSORY
This unit is designed to be started with an optional electric starter or
Power Start Bit™ that are sold separately. If choosing to start the unit
using one of these features or have questions please contact your local
retailer or call 1-877-282-8684 U.S, (1-800-668-1238 Canada), for
more information and purchasing. You may also go to www.cubcadet.
com or www.cubcadet.ca.
Electric Start Feature
Publicidad
