IKEA MITTZON Manual Del Usuario página 8

Troubleshooting MITTZON
Symptom
The table does not
move.
Orange light blinks.
Only one leg is
moving. Orange light
blinks.
The table stops and
reverses during
operation.
The table has stopped
working. Burning
smell from short-
circuit/motor/power
supply/control units.
Abnormal noise from
table leg.
One segment of the
3-segment leg does
not move.
Overheat protection
status.
Check
1. Make sure that all cables are undamaged
and connected firmly in place.
2. Unplug the desk from the wall socket for
approximately one minute and reconnect.
1. Make sure that all cables are undamaged
and connected firmly in place.
2. Unplug the desk from the wall socket for
approximately one minute and reconnect.
1. Make sure that the table is not overloaded.
(Max load 80 kg/176 lbs)
2. Make sure that nothing is blocking the table. Remove the obstacle. Follow the instructions to
3. Check that the electrical cable has full
movement when the desk is in its highest
position and has reasonable slack
Unplug the desk from the wall.
Check that the sound is normal or abnormal
when you move the desktop up and down.
/
/
Try
1. Reconnect all the cables.
2. Follow the instructions to perform a reset. If
the problem remains, contact IKEA customer
service.
1. Reconnect all the cables.
2. Follow the instructions to perform a reset. If
the problem remains, contact IKEA customer
service.
Remove the heavy things from the desk.
perform a reset.
If the electrical cable is trapped, release it. Make
sure it has enough length when the desk is in its
highest position.
Identify the burned parts, then contact IKEA
customer service.
Follow the instructions to perform a reset. If
problem remains, identify the defective parts
and contact IKEA customer service.
Follow the instructions to perform a reset. If
problem remains, identify the defective leg and
contact IKEA customer service.
This is not an error status, but due to the motor
working continuously, overheat protection may
activate. After approx. 18 minutes of rest, the
blue light will turn off and normal operation can
be resumed.
8