Wiring - AKO 52042 Manual De Uso

7.- Wiring

Always disconnect the power supply to do the wiring.
The power circuit should be equipped with a switch for its disconnection of at least 2 A, 230 V, situated near
the appliance.The power supply cable will be H05VV-F or H05V-K. The section tobe used will depend on
current local regulations, but should never be less than 1 mm .
Cables for wiring the relay contact should have an adequate section depending on the unit to be connected.
Make sure you have connected the batteries before starting-up the unit.
100-240 V~
50/60 Hz
SIM card slot
2
18
Mini-USB
connector
Battery
connector
DI1
DI2
Digital
inputs
DI3
DI4
Reset
button
Antenna
connector