STEP 3
To apply the detergent cleaner to your work area, attach the detergent
nozzle to the gun. Turn the pressure washer switch to the ON position.
Press the trigger to start the unit. The pressure washer will mix the
detergent with water. Do not allow the detergent to dry on the object
being cleaned.
WARNING: Never use products containing bleach, chlorine
or other corrosive materials, including solvent-based
liquids (e.g., gasoline, oils, etc.), trisodium phosphate
products, ammonia or acid-based cleaners. These
chemicals can cause damage to the unit and the surface
being cleaned. Always read the product label first.
CLEANING AND STORAGE
TURNING OFF THE PRESSURE WASHER
When you have finished using the pressure washer, follow these steps
to turn the unit off:
▶Turn the pressure washer to the OFF position.
▶Turn off the water supply.
▶Before disconnecting the high pressure hose connection, point the
gun in a safe direction and discharge the water under high pressure.
▶Disconnect the high pressure hose from the pressure washer and
the gun.
▶Disconnect the garden hose from the pressure washer.
▶Remove the quick coupling connector from the garden hose and
attach it to the nozzle part of the connector installed on the pressure
washer for storage.
▶Remove excess water from the pump by tilting the unit to both sides
to drain the remaining water from the inlet and outlet fittings.
▶Remove the water inlet filter and rinse it with water to remove any
dirt or debris. Replace the filter once it is clean.
▶Empty the detergent tank and rinse it under running water.
▶Clean any water residue from all parts and accessories.
▶Set the safety lock on the gun.
▶Store the pressure washer, parts and accessories in an area with a
temperature above 0 °C (32 °F).
Instruction manual
WINTERIZING AND LONG-TERM STORAGE
Follow the shutdown procedure above, adding the following steps:
▶After disconnecting the water supply and before
▶Always store the pressure washer, parts and accessories in an area
MAINTENANCE
▶This pressure washer is supplied with a closed lubrication system, so
▶Check all hoses and fittings for damage before use.
▶Periodically check the inlet filter for debris. Clean this filter regularly
CLEANING TIPS
WOOD AND VINYL DECKS
Rinse the surface to be cleaned and the surrounding area with fresh
water. If you are using detergent, fill the detergent tank and apply
to the area you are cleaning at low pressure. For optimum results,
reduce your work area to smaller sections and clean each section
one at a time. Allow the detergent to sit on the surface for a few
minutes and then rinse at high pressure. Do not allow the detergent
to dry. Always wipe from left to right and top to bottom for best
results. High pressure rinse using fan spray, keeping the tip of the
spray nozzle at least 15-25cm from the surface you are cleaning.
Maintain a greater distance from the surface when using a direct
spray. Caution: For softer woods, increase the distance from the
surface you are cleaning.
CONCRETE, STONE AND BRICK PATIOS
Rinse the surface to be cleaned and the surrounding area with
fresh water. If using detergent, fill the detergent tank and apply
to the area to be cleaned at low pressure. Rinse at high pressure
using the fan sprayer in a sweeping motion keeping the tip of
the spray nozzle at least 8-15cm from the surface to be cleaned.
Maintain a greater distance from the cleaning area when using a
straight sprayer.
23
disconnecting the high pressure hose, switch on the pressure
washer for 2 to 3 seconds, until the remaining water in the
pump comes out.
WARNING: Turn the unit off immediately. Continued use of
the pressure washer without turning on the water supply
will cause severe damage to the unit!
with a temperature above 0 °C (32 °F).
WARNING: Failure to follow these storage instructions
could result in damage to the pump assembly.
it is not necessary to add oil.
for maximum performance.
WARNING: Always test spray in an area free of people and
objects before applying to the intended cleaning surface.
ref. 08470
ES
PT
EN
FR