Publicidad
Idiomas disponibles
Idiomas disponibles
3. Gently shake the mesh filter to
distribute the coffee evenly.
4. Place the mesh filter into the
filter basket and place filter
basket into the brewing
chamber(see the figure)
5. Close the water reservoir lid.
6. Remove the lid from the mug
and place the mug into the base.
7. Plug the power cord into a standard
120volt AC electrical outlet.
8. Press the switch button; the indicator light will illuminate, verifying that the
coffeemaker is operating.
CAUTION: Don't open the reservoir lid during the brew cycle, as scalding may occur.
9. Allow all the coffee to drip from the brewing chamber into the mug before removing the mug .
Note: since coffee grounds absorb some water during brewing , the amount of brewed
coffee will be slightly less than the amount of water pure dint other reservoir.
10. When the brewing cycle is complete , the indicator light will shut off and the unit
will not longer heat.
11. If brewing another mug of coffee at this time proceed to the brewing a second
mug of coffee section, when all brewing is complete, unplug the power cord from
the electrical outlet.
12. Note: The Start Button on this product is a thermally-operated activation switch for
starting a brewing cycle. Pressing it again after the start of a brewing cycle will not
stop the product from operating. To interrupt a brewing cycle, unplug the product
from the electrical outlet. If the indicator light comes "ON" when the product is first
plugged in, wait approximately30seconds for it to go "off" before using the product.
Brewing a Second Mug of Coffee:
To brew another Mug of coffee, allow the Coffeemaker to completely cool (about
three minutes) after the Indicator Light has shut off. Rinse the Mug and the Reusable
Mesh Filter with water. Repeat the brewing procedure.
WARNING: If the Coffeemaker does not cool completely before reuse, water placed
in the Water Reservoir may overheat. This can cause steam to escape, resulting
in a risk of burns and/or personal injury.
NOTICE: Attempting to start another brewing cycle before the Coffeemaker cools may
result in an incomplete cycle; the unit employs a thermal reset switch to prevent
overheating and may shut down.
Water
reservoir lid
Water
reservoir
7
Reusable
mesh filter
Filter basket
Brewing
chamber
Publicidad
