Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
Functional description
The battery-powered router cutter is a
power tool equipped with a rotating cut-
ting tool (milling cutter) and a baseplate.
Stepless cutting depth adjustment and dust
suction enable comfortable working.
Refer to the following descriptions for a
functional description of the controls.
Technical data
Cordless Router ...................... POFA 12 B3
Motor voltage U
max
Idling speed n
......................19000 rpm
0
Milling cutter diameter .......... max. 36 mm
Rotational speed
of cutter n .....................max. 35000 rpm
Tool holder .......................... 6 mm/8 mm
Weight (without rechargeable
battery) .............................approx.1,1 kg
Sound pressure level
(L
) .......................... 66,8 dB; K
pA
Sound power level (L
Vibration (a
) ....... 2,031 m/s
h
Temperature...........................max. 50 °C
Charging process ...................4 - 40 °C
Operation .......................... -20 - 50 °C
Storage .................................0 - 45 °C
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
The specified vibration emission value and
the stated noise emission value have been
measured according to a standardised test
method and can be used to compare one
power tool with another.
The specified vibration emission value and
the stated noise emission value can also
be used for a provisional assessment of the
load.
26
......................12 V
pA
) ....77,8 dB; K
WA
WA
2
; K=1.5 m/s
Warning: The vibration emission
value whilst actually using the pow-
er tool may vary from the given values de-
pending on the type and way in which the
power tool is used as well as the type of
workpiece being processed in particular.
Try to keep the exposure to vibrations as
low as possible. One example of a meas-
ure to reduce vibration exposure when
using the tool is limiting the working hours.
All parts of the operating cycle have to be
considered while doing so (for example,
times when the power tool is switched off
and times when it is switched on but run-
ning without any load).
Charging time
The device is part of the X 12 V TEAM
series from Parkside and can be operated
using batteries of the X 12 V TEAM series
from Parkside. Batteries of the X 12 V
TEAM series from Parkside may only be
=3 dB
charged using chargers of the X 12 V
=3 dB
TEAM series from Parkside.
2
We recommend that you operate this appli-
ance with the following batteries only:
PAPK 12 A3, PAPK 12 B3, PAPK 12 D1
We recommend charging these batteries
with the following chargers:
PLGK 12 A2, PLGK 12 B2, PDSLG 12 A1.
Charging
time
(min.)
PLGK 12 A1
PLGK 12 A2
PLGK 12 A3
PLGK 12 B2
PDSLG
12
PAPK
PAPK
12 A1
12 A2
12 A3
60
60
30
45
A1
PAPK
12 B1
PAPK
12 B2
12 D1
12 B3
120
150
60
80
Publicidad
