Seiko DPU-S445 Guía Rápida página 4

Test Print
(1) Make sure the thermal paper is set
in the printer and the printer is turned
off.
If the thermal paper is not loaded, set
the thermal paper as instructed on the
previous page, „Setting the Thermal Pa-
per" and turn the printer off.
(2) Press the POWER and FEED
switches at the same time.
• Several dozens of lines are printed.
• After test printing, the printer goes into print-ready mode.
PRINTER STATE LAMP DISPLAY
Printer Status Error
Power OFF -
Power ON
-
(Print-ready)
Initializing -
Thermal paper is not
Out-of-paper error
inserted
Paper cover open
Paper cover is open
error
Battery low, power Power supply voltage is out
failure of the stipulated range
Thermal head tem- Thermal head temperature is
perature error out of the stipulated range
Recharging Battery pack is recharging
Function setting Mode where function
mode settings can be set
Function setting
-
mode shifting
Accessing FLASH
FLASH memory is operating
memory
Hardware error Error occurs in hardware
- *1: Range of stipulated power supply voltage is 6.5V ≤ power supply voltage ≤ 9.7V
- *2: Range of stipulated temperature is -10°C ≤ head temperature ≤ 80°C
(3) When the POWER lamp light up,
release the POWER switch, then the
FEED Switch.
NOTE
Display
POWER Lamp ERROR Lamp
Off Off
On Off
On On
On Blink
On Blink twice
Blink On
*1
Blink twice On
*2
Blink Off
Off On
Blink Blink
Short blink Short blink
Off Blink
Items
Blink
Short blink
Blink twice
TROUBLESHOOTING
□ The power does not turn on /
Power failure.
• Is specified AC adapter or battery
pack being used?
• Are the AC cable and AC adapter
connected correctly?
• Is the AC adapter connected to
the printer correctly?
• Is the battery pack sufficiently re-
charged?
□ The printer does not print.
• Is the interface cable connected
correctly?
• Are the specifications of the inter-
face cable conform to its specifi-
cations in the User's Guide?
• Are the communication method
and the function setting of the
printer correct?
• Is the Bluetooth communication
status good?
• Are the communication conditions
for the printer and the host device
correct?
• Is specified paper being used? Is
the paper orientation (surface /
back) correct?
Pattern
─ ○ ─ ○ ─ ○ ─ ........
○─○─○─○─○─○─○─○─○─○........
○─○ ─ ○─○ ─ ○─○ ─ .......
□ The battery runs out soon even if
recharged.
• Has the battery been recharged
correctly?
• If the battery pack is recharged
correctly, but does not last for
a long time, it is almost dead.
Replace it with a new one.
□ The ERROR lamp lights up or the
POWER lamp blinks.
• See the PRINTER STATE LAMP
DISPLAY.
• Is the printer function setting
correct?
□ The battery pack cannot be
installed?
• Was the battery pack inserted
correctly?
• Is the correct battery pack being
used?
EN
EN