Stinger HEIGH10 UN1810E Instrucciones De Montaje página 15

4D
4. Determine the desired position of the display:
a. Display can be vertical or tilted up. (FIG. T)
b. Display can slide up or down. (Page 7)
c. Display can be tilted horizontally. (Page 7 – FIG. B)
Note: There are multiple mounting holes on the mounting
bracket to allow adjusting the mounting depth. You may drill
additional holes in the mounting bracket and/or the dash kit
brackets to align the display in the best position and ensure
you can use 4 mounting screws.
5. Once in the desired position, tighten screws to the
mounting bracket assembly.
Note: If the display prevents the factory dash panel(s) from
being installed last, do not push the display all the way
up against the dash kit. Leave enough bottom gap as the
display's bottom edge rotates towards the dash kit.
6. Remove the display from the bracket assembly by
pushing up from compression spring side (1) and swing
out to unhook top (2).
(FIG. U)
Note: The plastic mounting bracket assembly may be
inverted to align the display in the best position. (FIG. V)
PROCEED TO STEP 5
on Page 16
FIG. T
B
M5 X 10
VERTICAL TILT: Use Hole A for no vertical
tilt or Hole B for 8 degrees of vertical tilt.
Insert a M5 X 10 on each side of the clamp
assembly at desired tilt.
2
1
FIG. V
M5 X 10
A
FIG. U
Compression Spring
15