GIA HTW-VTR-50LG Manual De Usuario página 9

Tower fan HTW-VTR-50LG USER MANUAL
2 ASSEMBLE THE STAND ONTO THE FAN BEFORE USE
1. Remove all packing material and accessories. Make sure all the accessories are included. In addition,
prepare an available screwdriver before assembling.
2. This fan must operate standing upright. Do not use it before finish assembling the base.
3. Gently turn the main body and Stand bases upside down. Insert the cord between the front and rear base
and assemble the two halves together until flush (refer to below figure).
4. Place Base Assembly onto the bottom of the mains body and fasten by using the four screws provided.
5. Gently guide the cord by using the plastic plate and two screws provided. Tighten the screws securely but
do not over tighten.
6. Turn the fan the correct way up and place it on a level and dry surface.
OPERATION
A. Connect the power and press Speed buttons (1, 2, 3). The fan will turn on and blow winds according to
the speed you chose.
B. Functions of Button:
a) 0FF: To stop the fan.
b) Speed setting (1, 2, 3): To select require fan speed by Low (1), Medium (2), High (3)
c) Oscillation: To start or stop the oscillation function. When press down the button, it will
move to oscillating. When second press, it will stop oscillating.
d) Timer: To pre-set the timer for the fan to operate at 10 minutes, 20 minutes, 30 minutes, 40 minutes, 50
minutes, and the maximum time allow is 120 minutes.
9
