Levenhuk Ermenrich NetGeeks NP60 Guia Del Usuario página 7

Specifications
Testing cable types
Cable length measurement
Cable length measurement range
Cable tracing
Wire mapping
Optical power meter function
Optical power meter wavelength
PoE test
Port Flash function
Cable crimping quality check
Visual fault locator (VFL)
Non-contact voltage detection function (NCV)
Backlight
Auto-off
Operating temperature range
Power supply
The manufacturer reserves the right to make changes to the product range and specifications without prior notice.
Care and maintenance
Do not use the device in a high voltage environment (e.g. 220V AC electric power supply). Do not use the device if it is not working properly. In
order to avoid lightning strikes, do not use the device during thunderstorms. Protect the device from sudden impact and excessive mechanical
force. Store the device in a dry cool place. Please note that the parameters of the power supply must comply with the technical characteristics
of the device. Do not touch any bare conductor with your hand or skin. Do not try to disassemble the device on your own for any reason. For
repairs and cleaning of any kind, please contact your local specialized service center. Only use accessories and spare parts for this device that
comply with the technical specifications. Never attempt to operate a damaged device or a device with damaged electrical parts! If a part of the
device or battery is swallowed, seek medical attention immediately.
Battery safety instructions
Always purchase the correct size and grade of battery most suitable for the intended use. Always replace the whole set of batteries at one
time; taking care not to mix old and new ones, or batteries of different types. Clean the battery contacts and also those of the device prior
to battery installation. Make sure the batteries are installed correctly with regard to polarity (+ and –). Remove batteries from equipment
that is not to be used for an extended period of time. Remove used batteries promptly. Never short-circuit batteries as this may lead to high
temperatures, leakage, or explosion. Never heat batteries in order to revive them. Do not disassemble batteries. Remember to switch off
devices after use. Keep batteries out of the reach of children, to avoid risk of ingestion, suffocation, or poisoning. Utilize used batteries as
prescribed by your country's laws.
Levenhuk International Warranty
Levenhuk products, except for their accessories, carry a 5-year warranty against defects in materials and workmanship. All Levenhuk accessories
are warranted to be free of defects in materials and workmanship for six months from the purchase date. The warranty entitles you to the free
repair or replacement of the Levenhuk product in any country where a Levenhuk office is located if all the warranty conditions are met.
For further details, please visit: levenhuk.com/warranty
If warranty problems arise, or if you need assistance in using your product, contact the local Levenhuk branch.
850/1300/1310/1490/1550/1625nm
PSE type test
Midspan/endspan identification
DC voltage measurement range
Voltage polarity detection
15 min, 30 min, 1 hour, 2 hours, OFF
–10... +60°C / +14... +140°F
transmitter: 3.7V 1500mA·h rechargeable lithium polymer battery
receiver: 3.7V 1500mA·h rechargeable lithium polymer battery
7
STP/UTP (CAT5, CAT6)
+
2.5–200m
+
+
+
standard (IEEE 802.3at/af) / non-standard
+
+
+
+
3 levels
+
5–60V
+