Descargar Imprimir esta página

Craftsman 917.377133 Manual Del Usuario página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

_CAUTION:
Do not run your lawn
mower without clipping deflector
or
approved grass catcher in place. Never
attempt to operate the lawn mower with
the rear door removed or propped open.
Catcher
frame@
handle
Frame
I
_
opening
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal
injury. If you
believe
that the engine
is running too fast
or too slow, take your lawn mower to a
Sears or other qualified service center for
repair and adjustment.
CARBURETOR
Your carburetor is not adjustable.
If your
engine does not operate properly due to
suspected
carburetor problems, take your
lawn mower to a Sears or other qualified
service center for repair and/or adjust-
ment.
IMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed.
Overspeeding
the
engine above the factory
high speed
setting can be dangerous.
If you think the
engine-governed
high speed needs
adjusting,
contact a Sears or other
qualified service center, which has proper
equipment
and experience
to make any
necessary
adjustments.
Immediately
prepare
your lawn mower for
storage at the end of the season
or if the
unit will not be used for 30 days or more.
LAWN MOWER
When
lawn mower is to be stored for a
period of time, clean it thoroughly,
remove
all dirt, grease,
leaves, etc. Store in a
clean, dry area.
1.
Clean entire
lawn mower
(See
"CLEANING"
in the Maintenance
section
of this manual).
2.
Lubricate
as shown
in the Mainte-
nance section
of this manual.
3.
Be sure that all nuts, bolts, screws,
and pins are securely
fastened.
Inspect
moving parts for damage,
breakage
and wear.
Replace
if
necessary.
4. Touch
up all rusted or chipped
paint
surfaces;
sand lightly before
painting.
HANDLE
You can fold your lawn mower
handle for
storage.
1.
Squeeze
the bottom
ends of the lower
handle toward
each other until the
lower handle
clears the handle
bracket,
then move handle forward.
2.
Loosen
upper handle
mounting
bolts
enough
to allow upper handle to be
folded
back.
IMPORTANT:
When folding the handle
for storage
or transportation,
be sure to
fold the handle as shown or you may
damage
the control
cables.
15
• When setting
up your handle from the
storage
position,
the lower handle will
automatically
lock into the mowing
position.
SQUEEZE
TO FOLD
Operator p
control bar
Upper
Lower
FOLD
BACKWARD
Mowing
position

Publicidad

loading