Descargar Imprimir esta página

Lifegoods SUP Board Touring LG1309 Manual De Instrucciones página 12

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
Always wear a life jacket (personal flotation device) and a safety lanyard (ankle cord). Check the
safety lanyard for wear after each use and replace it promptly if there is wear. Wear a helmet if
required or recommended by local regulations.
Always check for dangerous weather conditions or other hazards before using the product.
Always use the product in safe conditions. Do not use the product in adverse weather conditions
(such as strong winds, heavy rain or currents). Be aware of changing weather conditions. Avoid
using the product in downwind conditions. Take other precautions in other weather conditions,
such as in bright sunshine.
Do not use the product in conditions beyond the user's ability (such as high surf, currents, or
rapids in rivers). Do not use the product in waves higher than 0.3 m.
Do not use the product during thunderstorms, lightning, or in water with ice.
Never use the product after dark.
Do not use the product near other boat traffic, watercraft or in swimming areas. Do not tow the
product with a watercraft.
Do not inflate the product too hard or too soft. Use only the pump provided to inflate the product.
Do not inflate the product beyond the specified PSI/bar. Do not over-tighten the valves.
Do not use the product if you are under the influence of alcohol, drugs, medications or other mind-
altering substances.
Make sure you are never more than 150 meters from land.
Always follow relevant local regulations. These regulations may include wearing life jackets or
other safety equipment; using fairways; right of way when passing other vessels; permits and
licenses.
Always carefully transport the product when it is inflated. Do not transport the product on top of a
vehicle.
Do not navigate alone when using the product. Use it for safety in groups.
2.4 Medical remarks
Consult a doctor before using the product if you have unexplained pain, undergo medical
treatment, or use medical equipment.
3. INSTRUCTIONS FOR USE
3.1 Inflating
1.
Choose a smooth, stable and horizontal surface.
2.
Remove the product from the backpack and roll it out completely.
3.
Remove the protective foam rubber from the rear fins.
4.
Unscrew the valve cap.
Make sure the valve pin is up. If the valve pin is not up, turn it counterclockwise until it comes up.
22
5.
Attach the black end of the tubing to the pump on the side with the letters 'INF'.
6.
Attach the gray end of the tubing to the product and twist clockwise to secure the tubing.
7.
Place the pump on a hard, flat and stable surface. Place your feet on the pump's footrest and
begin pumping. If you are inflating the product for the first time, it may take more effort.
It takes about 5 minutes to inflate the product.
8.
When the product is inflated, turn the gray end counterclockwise to release the pump.
9.
Place the cap on the valve and turn it clockwise to close it. Use the valve wrench provided to
tighten the valve extra tight.
3.2 Attaching the fin
1.
Turn the product over so that the slot for the fin is facing up.
2.
Slide the fin into the slot.
3.
Take the attached pin and slide it through the notch on the sides of the slot.
3.3 Attaching the ankle cord
Snap the ankle cord to the ring at the end of the product.
3.4 Assembling the paddle
1.
Press the pin on the rod of the lower part of the paddle inward. Slide the upper part of the
paddle onto the lower part.
2.
Rotate the upper part until the pin snaps into the hole in the tube of the upper part.
1.
2.
3.5 Deflating
There are two ways to empty the product: with the pump or manually.
English
23

Publicidad

loading

Este manual también es adecuado para:

Sup board touring lg1311