Publicidad
Idiomas disponibles
Idiomas disponibles
8.
It takes about 5 minutes to inflate the product.
9.
When the product is inflated, turn the gray end counterclockwise to release the pump.
10.
Place the cap on the valve and turn it clockwise to close it. Use the valve wrench provided to
tighten the valve extra tight.
3.2 Attaching the fin
1.
Turn the product over so that the slot for the fin is facing up.
2.
Slide the fin into the slot.
3.
Take the attached pin and slide it through the notch on the sides of the slot.
3.3 Attaching the ankle cord
Snap the ankle cord to the ring at the end of the product.
3.4 Assembling the paddle
1.
Press the pin on the rod of the lower part of the paddle inward. Slide the upper part of the paddle
onto the lower part.
2.
Rotate the upper part until the pin snaps into the hole in the tube of the upper part.
3.5 Deflating
There are two ways to empty the SUP board: with the pump or manually.
English
23
Publicidad
Capítulos
