Descargar Imprimir esta página

Craftsman 917.9998C Manual Del Usuario página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

TO CHANGE ENGINEOIL
NOTE: Before tipping lawn mower to drain
oil, empty fuel tank by running engine until
fuel tank is empty.
1. Disconnectspark plug wire from spark
plug and place wire where it cannot
come in contact with plug.
2. Remove engine oil cap; lay aside on a
clean surface.
3. Tip lawn mower on its side as shown
and drain oil into a suitable container.
Rock lawn mower back and forth to re-
move any oil trapped inside of engine.
5. Lightly coat foam element with clean
engine oil. Squeeze in towel to re-
move excess oil. Do not saturate.
6. Install foam element, then replace
cover.
Slot
4. Wipe off any spilled oil from lawn
mower or side of engine.
5. Slowly pour oil down the oil fill spout,
stopping every few ounces to check the
oil level with the dipstick.
6. Stop adding oil when you reach the
FULL mark on the dipstick.
Wait a
minute to allow oil to settle.
7. Continue adding small amounts of oil,
rechecking
the dipstick until oil level
settles at FULL.
DO NOT overfill, or
engine will smoke heavily from the muf-
fler on startup.
8. Always be sure to retighten oil dipstick
before starting engine.
9. Reconnect spark plug wire to plug.
AIR FILTER
Your engine will not run properly and may
be damaged by using a dirty air filter.
Replace the air filter every 100 hours of
operation or every season, whichever
oc-
curs first. Service air cleaner more often
under dusty conditions.
TO CLEAN AIR FILTER ELEMENT
1. Remove cover.
2. Carefully
remove foam element.
3. Wash foam element in liquid detergent
and water.
4. Wrap foam element in cloth and
squeeze dry.
Foam
element
Cover
MUFFLER
Inspect and replace corroded
muffler as it
could create a fire hazard and / or damage.
SPARK PLUG
Replace spark plug at the beginning
of
each mowing season or after every 100
hours of operation,
whichever
occurs
first. Spark plug type and gap setting
are shown in the "PRODUCT
SPECIFIC-
ATIONS" section of this manual.
13
CLEANING
IMPORTANT:
For best performance,
keep mower housing free of built-grass
and trash. Clean the underside of your
mower after each use.
,_,CAUTION"
Disconnect
spark plug wire
from spark plug and place wire where it
cannot come in contact with plug.
• Clean the underside of your lawn
mower by scraping to remove build-up
of grass and trash.
• Clean engine often to keep trash from
accumulating.
A clogged engine runs
hotter and shortens engine life.
• Keep finished surfaces and wheels free
of all gasoline, oil, etc.
• We do not recommend
using a garden
hose to clean lawn mower unless the
electrical
system, muffler, air filter and
carburetor
are covered to keep water
out. Water in engine can result in short-
ened engine life.

Publicidad

loading