ECOVACS GOAT G1 Instalación página 13

INSTALL THE NAVIGATION BEACON
Note: Navigation Beacon is composed of the Beacon and the Navigation-assisted Pole.
Assemble the Navigation Beacon
1
1. Disassemble the Beacon by turning the upper Beacon counterclockwise.
2. Please remove the protection materials inside the Beacons and then install the Dry Cells.
3. Pay attention to the correct match of positive and negative polarity.
4. Assemble the Beacon by turning the upper Beacon clockwise. You will hear the sound of "beep" if the Beacon is correctly connected. Continue
screwing for a firm connection.
5. Insert the Beacon into the Navigation-assisted Pole by aligning projections on the Beacon with grooves of the Navigation-assisted Pole.
6. Turn Beacon clockwise until you hear a "click".
Beep~ Click~
CAUTION
1. Risk of explosion if the battery is replaced by an incorrect type.
2. Powered by 3pcs of type D alkaline batteries.
13 EN