Nice WEGO LECTOR RFID Manual página 22

05 - MOUNTING
Secure the product base to the desired installation location (e.g. wall) using two screws, as shown in the image below:
2 - There is a hole in the rubber gasket for the installation wires. However, if this hole is insufficient for installation,
enlarge it with a knife, as shown in the image below:
NOTES: Cut only what is necessary for the passage of the wires.
After passing the wires, fit the product to the base. First at the top and then at the bottom. Then secure the parts
through a screw, located at the bottom, as shown in the image below:
22
NOTES: We recommend 3.5mm x 30mm
screws (diameter x length) and 5mm
bushings.
ENGLISH