Publicidad
Idiomas disponibles
Idiomas disponibles
4.0
1
7
1
Mode Key
•
welding process selection
•
return to the main screen after parameters setting
2
Graphic Display
3
Setup Key
setting of the secondary parameters in all welding processes
3.1 Tig Function
2stroke/4stroke, Slope Up (0-10 sec), Slope Down (0-20 sec), crater Filler value in 4stroke function only, Post Gas
Time 0-5 sec
3.2 Mig/Mag Function
Synergy: OFF /ON/PULSED, 2Stroke/4Stroke/Spot welding, Spot Time, Motor Slope, BBT, Electronic Inductance,
Post Gas, Crater Filler
4
Prog save & recall Key
saves and recalls the functioning points that may be changed by the operator
5
Right Regulation Knob ( Volts / Amps)
Main Regulation Knob
6
Material Key
submenus selection key
6.1 TIG
•
NORMAL
•
PULSED:
• Pulse Frequency
•
• I Max (peak current)
• I Min (base corrent)
7
Left Regulation Knob
7.1 MMA
•
HOT START
MODE Key works as BACK key in all menus.
SETUP Key allows to run through the menus by selecting in sequence the modifiable parameters.
The right knob changes the value previously selected with the SETUP Key.
8 8
CONTROL INTERFACE
6.2 MIG/MAG
( Ton)
7.2 TIG
•
Slope Down ( Tig )
•
Pulse Frequency (Pulsed
Tig)
2
6
6.2.1 Manual Mig/Mag (synergy OFF)
Adjustment of the electronic inductance value
6.2.2 Synergic Mig/Mag/ Synergic Pulsed
Screen access for the synergic program selection
3
4
5
Figure 1
7.3 MIG/MAG
•
Wire speed ( Mig )
•
Balance
(Synergic
pulsed Mig)
and
27
Publicidad
