Segway-Ninebot eKickScooter E2 Pro Manual Del Producto página 6

página de 49

/ 49
Marcadores

Idiomas disponibles

Recommended Maintenance Schedule

To ensure safe riding, day to day care and regular maintenance are essential. You, the owner, have˜control˜and˜knowledge˜of˜

how˜often˜you˜use˜your˜scooter,˜how˜hard˜you˜use˜it˜and˜where˜you˜use˜it. It is the owner's responsibility to perform regular

checks and bring your scooter to authorized service center for inspection and service. Please refer to the maintenance

schedule below.

Note: This maintenance schedule charges a service fee.

Item

Component

Maintenance Method

Mainframe parts Use a soft, wet cloth to wipe the mainframe clean.

Tire pressure

Inflate the tires to 50–55 psi.

Tighten the six screws fixed with the handlebar and

the stem. The suggested torque is 5.5±0.3 N·m.

Tighten the screw on the throttle. The

Mainframe

Screws on the

suggested torque is 2.5±0.1 N·m.

maintenance

stem top

Tighten the screws on the brake levers. The

suggested torque is 5±0.1 N·m.

Tighten the screws on the stem top. The

suggested torque is 1.7±0.1 N·m.

To accelerate and decelerate, check if the hub motor

Hub motor

is stalled or has abnormal sounds.

Rear wheel

Check if the rear wheel is stalled or gets shaky, or the

axis shaft is unbalanced.

maintenance

Function

1) Spin the rear wheel, it spins normally. The rear

Inspection

wheel shall not stuck or make abnormal sounds.

Note: Slight noise does not aﬀect riding safety. But if the

Drum Brake

drum brake makes loud noises when you apply brakes,

please contact customer service for support.

the brake lever, the rear wheel stops moving.

Every 6 months or

After 2 years or

Every 3 every 310

the total

months miles (500

km)

mileage > 3107

miles (5000

km)

2) Squeeze

Item

Component

Maintenance Method

Ambient light

Check the ambient light and see if it lights normally.

Headlight

Check the headlight and see if it lights brightly.

Toggle the direction indicator switch to the left/right

Direction

respectively, check if the direction indicators on the

Indicators

left/right side flash normally.

Dashboard

Power on the scooter, the dashboard works properly.

Press and hold the throttle, then release it, checking

Throttle

for acceleration and deceleration.

After connecting with the Segway-Ninebot app:

Function

1) Update the firmware to the latest version.

Inspection

Fault

2) Check if the notification of the corresponding error code and

detection

possible causes will prompt when the scooter detects an error.

Charge the scooter:

1) Check if the current battery power displays on the

Charging

dashboard. 2) Check the LED indicator on the battery charger.

Charging: red, Fully charged: green.

Buttons

Press or toggle the button 3 times without failure.

Test with left turns and right turns (the steering angle is

Steering

60°). No resistance or lag when turning.

The battery need to be replaced when it is charged and

discharged for 500 times or the total mileage is more

Battery

than 9320 miles (15000 km).

assembly

Important

Note: It is recommended to charge once every 60 days

parts

for long-term storage.

Controller

It is required that original Segway-Ninebot parts shall be

used for repairs and replacements.