Waterdrop PAWAii Wireless Pet Water Fountain Pro Manual Del Usuario página 4

Operation Modes of External Water Pump
Power On/Off: Hold the key at the top for 3 seconds.
Auto Dispensing: The fountain dispenses water once every hour and dispenses automatically once
sensing pet's presence.
Manual Dispensing: Press the key at the top to dispense water once when the device is on.
Filter Countdown Reset: Press the key at the top four times to reset the filter countdown.
Note:
• The fountain automatically repels floating hair once every 8 hours. It will repel floating hair and
residue in 1 minute. The flow of water would increase during the period, as well as the operating
sound, which is normal.
Recharging Instructions
The external water pump
can be recharged separately.
Please turn off the device
in advance.
Note:
• The base cannot be recharged separately.
• Do not recharge the external water pump and base simultaneously.
• When the battery power is too low, the device will automatically shut down and enter a hibernation
state. To wake it, press and hold the external water pump key for 3 seconds, and the red indicator will
flash 5 times.
• Do not recharge the device with an adapter exceeding 5V/2A.
Cleaning and Maintenance
Please clean the filter, external water pump filter tube, water tray, water tank, and other parts every
7 days.
Note: Please turn the device off a few minutes before washing. The external water pump can be
wiped but do not soak in water. The metal docking area between the external water pump and the
base must be kept dry.
Filter Replacement
1. The filter must be replaced every 30 days. The yellow light will flash if the filter lifespan is shorter
than 3 days.
2. After replacing the filter, tap the external water pump key four times consecutively to reset the
filter lifespan. Once the reminder lights are off, the filter restarts its new round of 30-day
countdown. Follow the steps below to replace a new filter:
The base can also be recharged but with
(
the external water pump
plugged in .
)
External Water
Pump Filter Tube
7
Step 1: Remove the filter and tear off the
heat shrinkage film on its surface. Then
soak the filter in water for 5 minutes.
3
1
2
Step 3: Install the new filter and place
the water tray and external water pump
back in that order.
Note: When the device is shut down, the countdown of filter's lifespan will still continue.
Weighing Data Reset
To reset the weighing data, place the base of the fountain on hard floors and connect it to a power
cord, and remove the external water pump, water tank and water tray at the same time. The reset is
complete once the green indicator of the network configuration key flashes twice. Please reset it every
time the device is repositioned.
Factory Reset
Press and hold the reset key you may need tools to activate the key
(
seconds to reset the device after a beep sound.
Note: The reset requires the placement of external water pump onto the
base.
1
3
2
Step 2: Pick up the external water
pump and water tray, and remove
the old filter.
Ty pe
-c
Ty pe
-c
Step 4: Reset the filter lifespan on the
device or APP after the replacement is
complete.
for 3
)
8