Publicidad
Idiomas disponibles
Idiomas disponibles
Use
− Do not pull the inflated pool over the ground.
− Set up the pool in the location where you would like to use
it.
1. Carefully fold the pool apart.
2. Check all seams and surfaces for damage.
3. Stretch the large sling on a screw-on valve
corresponding thread on the bottom air chamber
4. Place the screw-on valve on the thread opening and screw it tight (see Fig. B).
5. Open the top cap of the screw-on valve and connect bellows or a double-
action pump.
6. Inflate the air chamber.
7. Once inflated, pull the pump or the bellows out of the screw-on valve and
close the thread.
8. Repeat steps 3–7 for the top air chamber
Make sure that you inflate both air chambers equally.
9. Place a pump on the valve
10. Inflate the headrest.
11. Take the pump off, put the plug on the valve and push it into the headrest.
Filling the pool with water
WARNING!
Risk of injury!
Improper filling may lead to injury.
− Make sure that the water is evenly distributed. If the water
is unevenly distributed or the pool leans to one side, the
ground is not level enough and there is an increased risk
of slipping. Immediately stop the flow of water. Drain the
water and find a new, suitable location.
− Pool presents a drowning hazard even during filling and
draining of the pool. Maintain constant supervision of
children and do not remove any safety barriers until the
pool is completely empty and stowed away.
14
1
for the headrest
8
6
and lay it over the
3
.
.
.
2
Publicidad
