TO START/STOP MASSAGE ACTION
Before using, first read all of the instructions including the warnings and safety
precautions as well as the section on programmed and manual massage.
(BEGINNING OPERATION)
1. To operate the massage, push left side button.
e Check to be sure the operation indicator lamp is lit.
Départ/remise á zéro
VS
o
[
nroarammed
Z N |
2. If you wish to stop the massage temporarily, push right side button.
The massage heads will stop where they are.
e Check to be sure the operation indicator goes out. To resume massage press left side
button.
Q
I/S
Q
Í programmed (ZN)
3. After final use, push the left side button to restore massage heads.
e The massage heads will go up, spread out and stop in the restore position. With the
heads in this position you can sit comfortably, using the massager as a regular chair.
e Be sure to store the controller in the pocket on the side of the right armrest when not in
use.
a
start
| reset
tS
O
Í nranrammed 7
|
IMPORTANT NOTE: If you have never had a massage, we suggest you start in the manual mode.
Automatic timer for massage lounger
e To prevent excessive massaging there is a built-in timer which after approx. 15 minutes of
operation will automatically turn the massage heads to the "restore" position and stop their
motion.
e Turning on the operation switch while the massage heads are moving to the restore position
will reset the time for another 15 minutes (approximately).
e lf the programmed massage button is pushed, the unit will stop after finishing the program.
10